Programming Steps - Wired
Scan the factory default barcode for the model of scanner
Unplug the scanner
Wait 5 seconds
Plug the scanner back into the computer
Scan the programming document for your specific scanner (DOCUMENTS FOUND BELOW)
Unplug the scanner
Wait 5 seconds
Plug the scanner back into the computer
Check control panel, it should show as a keyboard at the top.
Scan something into notepad. It should show like something below
<COUPON>
Programming Steps - Wireless
Unplug connection cable from cradle to computer
Scan the factory default barcode for the model of scanner
Put the scanner on the cradle to pair the scanner to the cradle
Scan the programming document for your specific scanner (DOCUMENTS FOUND BELOW)
Put the scanner on the cradle to resync the scanner and cradle
Plug connection cable from cradle to computer
Check control panel, it should show as a keyboard at the top
Scan something into notepad. It should show like something below
<COUPON>
Wired Scanners
DS6707 Model Programming Barcodes
Wireless Scanners
DS6878 Model Programming Barcodes - (LIMITED MODELS)
DS3678 Model Programming Barcodes
If the scanner is only scanning in correctly with CAPSLOCK off, then scan the ‘No Case Conversion’ Barcode for the model being used